EV1 Injector Connector 2-Way 90-Degree Rubber Boot — Angled Fuel Injector Connector Protection
The 90-Degree Rubber Boot for EV1 2-Way Connector — SKU: PRO90EV is a 90-degree angled flexible rubber boot for the 2-way EV1 / JPT fuel injector connector — the angled-exit variant of the EV1 injector connector boot for installations where the injector wiring must exit at right angles to the injector connector face. Used in motorsport and performance engine management wiring across Norway, Sweden, and Denmark.
90-Degree Exit — When Injector Wiring Must Route Along the Engine
On many motorsport engine configurations — particularly side-draft and downdraft carburettor replacement injection setups, direct-port injection manifolds, and tightly packaged turbocharged engine bays — the injector connector exits in a position where the harness must immediately route along the cylinder head or manifold surface rather than exiting straight from the connector. The 90-degree boot accommodates this routing requirement, keeping the wire bundle close to the engine surface and reducing harness bulk in the engine bay without creating a stress point at the connector entry.
Key Features
- 90-degree angled exit — routes harness along engine surface from the injector connector
- 2-way — fits EV1 / JPT fuel injector connector format
- Flexible rubber — vibration isolation and strain relief
- Suitable for tightly-packaged engine bays and side-routed injector harness installations
Reviews
There are no reviews yet.